Investigation of Frequency Dependent Electrical and Dielectric Properties of Maple Wood (Acer Trautvetteri Medw.) with Different Surface Treatments

dc.contributor.authorBozali, Beytullah
dc.date.accessioned2026-07-01T11:39:15Z
dc.date.available2026-07-01T11:39:15Z
dc.date.issued2026
dc.departmentDüzce Üniversitesi
dc.description.abstractIn this study, the electrical and dielectric properties of maple wood (Acer trautvetteri Medw.) were comprehensively investigated under three different surface conditions: untreated control (CW), two-week water immersion (SW), and double varnish (VW), as well as a function of frequency. For the accuracy of electrical analysis, all test samples were evaluated in a dry state and comparative analysis was performed between surface treatment groups. In the experimental analyses in the frequency range from 100 Hz to 1 MHz, reel/imaginary part of dielectric permittivity (epsilon ' and epsilon ''), dielectric loss factor (tans), alternating current electrical conductivity (sigma ac), specific heat capacity (C), conductivity-dependent free energy component (G/omega), and real (Z ') and imaginary (Z '') impedance components were comprehensively evaluated. According to the test results, the SW test samples, with their high (epsilon ') and (epsilon '') values, were found to provide significant ionic and dipolar contributions. However, due to their high (tans) and (sigma ac) values, their energy storage capacity is limited, and their conductivity potential is high. The VW test samples, with their low (epsilon '') and (tans) values, exhibit strong insulating properties, making them suitable for high-frequency capacitive applications. The CW test samples, in contrast, exhibit a balanced conductivity-insulation profile with moderate dielectric response. Impedance analyses (Z ', Z '') revealed that the low-resistance ion transport mechanism dominates in the SW test samples, while the surface coating creates a high-resistance barrier, thus limiting charge transport in the VW test samples. The (G/omega) results indicate high energy dissipation in the SW test samples over a wide frequency range, while the VW test samples exhibit stable storage behavior with low energy loss. According to the test results, maple wood, depending on the surface treatment, has potential for use in sensor technologies (SW), radiofrequency isolating components (VW), and general structural dielectric applications (CW), and allows for targeted performance engineering through material modification.
dc.identifier.doi10.53502/wood-211284
dc.identifier.issn1644-3985
dc.identifier.issn2956-9141
dc.identifier.issue217
dc.identifier.scopus2-s2.0-105033263963
dc.identifier.scopusqualityQ3
dc.identifier.urihttps://doi.org/10.53502/wood-211284
dc.identifier.urihttps://hdl.handle.net/20.500.12684/23182
dc.identifier.volume69
dc.identifier.wosWOS:001708725100001
dc.identifier.wosqualityQ3
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.institutionauthorBozali, Beytullah
dc.language.isoen
dc.publisherLukasiewicz Research Network, Poznan Inst Technology
dc.relation.ispartofDrewno
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/openAccess
dc.snmzKA_WOS_20260623
dc.subjectMaple Wood
dc.subjectDielectric Properties
dc.subjectFrequency-Dependent Behavior
dc.subjectComplex Impedance
dc.subjectElectric Modulus
dc.titleInvestigation of Frequency Dependent Electrical and Dielectric Properties of Maple Wood (Acer Trautvetteri Medw.) with Different Surface Treatments
dc.typeArticle

Dosyalar