Assessment of Conical Die Deep Drawability of DP800 and MART1400 Advanced High Strength Steels
Yükleniyor...
Dosyalar
Tarih
2023
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Society of Automotive Engineers Turkey
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
Deep drawing is one of the most important and vastly conducted sheet metal forming method. Thus, even small improvements achieved on the deep drawability of sheet metals significantly increases the ability of sheet metal to be formed into more complex products. Advanced high strength steels (AHSSs) are one of the most popular steels in the automotive industry due to their high strengths. However, their low ductility causes considerable splitting problems near the cup punch region. In this study, deep drawing experiments have been conducted in conical dies with four different angles (0°, 7.5°, 12.5°, and 20°) for DP800 and MART 1400 steels to observe whether a higher deep drawing ratio (DDR) can be achieved by deep drawing in conical dies for AHSSs. In addition, finite element analysis (FEA) has been utilized to estimate the DDR for each types of steels in different conical die setups. It has been observed that the deep drawability of MART1400 steel has not improved in any of the conical die setups. However, DDR of DP800 has slightly increased by 2.46% by deep drawing with 20° die angle. A good agreement with the numerical and experimental results has been achieved. © 2023 Universidade do Vale do Rio dos Sinos. All rights reserved.
Açıklama
Anahtar Kelimeler
Conical die deep drawing, Deep drawing ratio, DP800, MART1200
Kaynak
International Journal of Automotive Science and Technology
WoS Q Değeri
Scopus Q Değeri
N/A
Cilt
7
Sayı
2
