Effect of reciprocating sliding speed on the tribological performance of nano SiCp reinforced Ni-metal matrix composites produced by electrocodeposition
Yükleniyor...
Dosyalar
Tarih
2012
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
In the present work, Ni/SiC metal matrix composite (MMC) coatings were prepared from a modified Watt's type electrolyte containing nano-SiC particles by direct current (DC) plating method to increase wear resistance of the electro co-deposited Ni. SiC nano particles with average particle size of 0, 1-1 ?m were co-deposited with nickel matrix on the steel substrates. For this purpose, several studies were carried out to optimize deposition parameters for specific applications. The depositions were controlled to obtain the specific thickness (between 175-200 ?m) and particle volume fraction in the matrix (between 0.03 and 0.10). The hardness of the resultant coatings was measured and found to be 280-571 HV depending on the particle concentration in the electrolyte and therefore, particle volume in the Ni matrix. The tribological tests were performed by a reciprocating ball-on disk apparatus sliding against M50 steel ball (ø10 mm). All the friction and wear tests were performed under the unlubricated conditions at room temperature and in the ambient air (relative humidity 55-65%). The wear tests were carried out at different sliding velocities of 50 mm/s, 100 mm/s and 150 mm/s by using a constant dead load of 1.0 N. It was detected that increasing sliding speed resulted to increase wear rate but decreasing friction coefficient due to change in wear mechanism. Increasing sliding speed showed formation of tribo induced oxides up to 20 g/l SiCp in the electrolyte and wear mechanism was controlled by temperature induced fatigue wear. Further increase in the SiCp in the electrolyte caused an abrasive type of the wear. Copyright © 2012 American Scientific Publishers All rights reserved.
Açıklama
Anahtar Kelimeler
Electro-codeposition; Fatigue wear; Nano composite; SiC; Sliding speed
Kaynak
Journal of Nanoscience and Nanotechnology
WoS Q Değeri
Scopus Q Değeri
N/A
Cilt
12
Sayı
12
