Investigation of Surface Morphology of Drilled Cfrp Plates and Optimization of Cutting Parameters
Yükleniyor...
Dosyalar
Tarih
2020
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
World Scientific Publishing Co. Pte Ltd
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
In this study, the carbon fiber reinforced polymer (CFRP) composite material was drilled using different parameters (118° and 140° Point Angle, 30, 60 and 90m min-1 cutting speed and 0.06, 0.08 and 0.10mmrev-1 feed rate). Experimental parameters were designed according to full factorial design method and the results were analyzed using Taguchi L18 experimental design. The results of the study show that the lowest surface roughness values are 0.1958 and 0.1945?m with the cutting speed of 90 mmin-1 and feed rate of 0.06mrev-1 in the Point angles of 11° and 140°, respectively. When the results of Anova analysis were evaluated, parameters (feed speed, cutting speed and end point angle) according to the effect ratios on surface roughness were formed at the rates of 41.06%, 33.13% and 5.07%, respectively. The most suitable parameters according to S/N ratios were determined using A2B3C1 factors for the average surface roughness. © 2020 World Scientific Publishing Company.
Açıklama
Anahtar Kelimeler
3D surface roughness; CFRP composite material; drillability; Taguchi method
Kaynak
Surface Review and Letters
WoS Q Değeri
Scopus Q Değeri
Q3
