CUTTING TOOL GEOMETRY IN THE DRILLING OF CFRP COMPOSITE PLATES AND TAGUCHI OPTIMISATION OF THE CUTTING PARAMETERS AFFECTING DELAMINATION

Basit Öğe Kaydı
dc.contributor.authorSur, Gökhan
dc.contributor.authorErkan, Ömer
dc.date.accessioned2020-05-01T09:11:16Z
dc.date.available2020-05-01T09:11:16Z
dc.date.issued2018
dc.departmentDÜ, Teknoloji Fakültesi, Makine ve İmalat Mühendisliği Bölümüen_US
dc.descriptionWOS: 000445810300003en_US
dc.description.abstractIt is possible to improve the hole quality by reducing the delamination which occurs in the drilling of carbon fibre reinforced plastic (CFRP) composite plates. For this study, carried out under dry machining conditions, the parameters included three different cutting speeds, three different feed rates and drill geometry involving three different point angles. The Taguchi L-9 orthogonal array experimental design was selected and the optimum cutting parameters and drill geometry for reducing the damage factor to a minimum were determined. The optimum test conditions were achieved using the parameter combination of 118 degrees point angle, 30 m/min cutting speed and 0.06 mm/rev feed rate (A1B1C1). In addition, variance analysis (ANOVA) was conducted to determine the effect rate of the parameters on the damage factor. The variable having the greatest effect on the damage factor was found to be the point angle (47.66%), followed by the cutting speed (24.44%) and feed rate (19.82%). The conditions for minimising delamination damage in the drilling of the CFRP plates were optimised successfully by using the Taguchi test design.en_US
dc.identifier.endpage628en_US
dc.identifier.issn1304-7205
dc.identifier.issn1304-7191
dc.identifier.issue3en_US
dc.identifier.startpage619en_US
dc.identifier.urihttps://hdl.handle.net/20.500.12684/5444
dc.identifier.volume36en_US
dc.identifier.wosqualityN/Aen_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isoenen_US
dc.publisherYildiz Technical Univen_US
dc.relation.ispartofSigma Journal Of Engineering And Natural Sciences-Sigma Muhendislik Ve Fen Bilimleri Dergisien_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectCFRP compositeen_US
dc.subjectdrillingen_US
dc.subjectdelaminationen_US
dc.subjectdesign of experimentsen_US
dc.subjectANOVAen_US
dc.titleCUTTING TOOL GEOMETRY IN THE DRILLING OF CFRP COMPOSITE PLATES AND TAGUCHI OPTIMISATION OF THE CUTTING PARAMETERS AFFECTING DELAMINATIONen_US
dc.typeArticleen_US

Dosyalar

Orijinal paket
Listeleniyor 1 - 1 / 1
Küçük Resim Yok
İsim:
5444.pdf
Boyut:
793.18 KB
Biçim:
Adobe Portable Document Format
Açıklama:
Tam Metin / Full Text
İndir

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Makale Koleksiyonu