Optimization of flank wear and surface roughness during turning of AISI 304 stainless steel using the Taguchi method

Basit Öğe Kaydı
dc.authoridOZBEK, Onur/0000-0002-8372-3487
dc.contributor.authorOzbek, Nursel Altan
dc.contributor.authorKaradag, Metin Ibrahim
dc.contributor.authorOzbek, Onur
dc.date.accessioned2021-12-01T18:46:58Z
dc.date.available2021-12-01T18:46:58Z
dc.date.issued2020
dc.department[Belirlenecek]en_US
dc.description.abstractThis paper presents the effect of cutting tool, cutting speed and feed rate on the flank wear and surface roughness of austenitic stainless steel (AISI 304) during wet turning. Turning tests were designed based on the Taguchi method (L18). An orthogonal array, the signal-to-noise ratio (S/N) and the ANOVA were used to investigate the machinability of AISI 304 stainless steel with PVD and CVD coated tungsten carbide inserts. As a result of ANOVA, it was found that the feed rate was the most effective parameter on both flank wear and surface roughness.en_US
dc.identifier.doi10.3139/120.111571
dc.identifier.endpage961en_US
dc.identifier.issn0025-5300
dc.identifier.issue9en_US
dc.identifier.startpage957en_US
dc.identifier.urihttps://doi.org/10.3139/120.111571
dc.identifier.urihttps://hdl.handle.net/20.500.12684/10075
dc.identifier.volume62en_US
dc.identifier.wosWOS:000568266500013en_US
dc.identifier.wosqualityQ3en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isoenen_US
dc.publisherCarl Hanser Verlagen_US
dc.relation.ispartofMaterials Testingen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectAISI 304 austenitic stainless steelen_US
dc.subjectPVD/CVD coatingen_US
dc.subjectflank wearen_US
dc.subjectsurface roughnessen_US
dc.subjectoptimizationen_US
dc.subjectAustenitic Stainless-Steelen_US
dc.subjectCutting Parametersen_US
dc.subjectDesign Optimizationen_US
dc.subjectTool Wearen_US
dc.subjectPvden_US
dc.subjectTemperatureen_US
dc.subjectPredictionen_US
dc.subjectCoatingsen_US
dc.titleOptimization of flank wear and surface roughness during turning of AISI 304 stainless steel using the Taguchi methoden_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu