OPTIMIZATION of the MACHINING PARAMETERS in TURNING of HARDENED HOT WORK TOOL STEEL USING CRYOGENICALLY TREATED TOOLS

Yükleniyor...
Küçük Resim

Tarih

2019

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

World Scientific Publishing Co. Pte Ltd

Erişim Hakkı

info:eu-repo/semantics/closedAccess

Özet

This paper addresses an approach based on the Taguchi method with gray relational analysis for optimizing the turning parameters of hardened DIN 1.2344 hot work tool steel (54 HRC) with multiple performance characteristics. A gray relational grade obtained from the gray relational analysis was used for the performance characteristic in the Taguchi method L18 (21×32). The optimal turning parameters for surface roughness and tool wear were determined using the parameter design proposed by the Taguchi method. Dry turning tests were carried out using cryogenically treated and untreated uncoated carbide cutting tools. The cutting tool (Untreated and Deep Cryogenic Treated), cutting speed (200, 250 and 300m/min) and feed rate (0.09, 0.12 and 0.15mm/rev) were selected as experiment parameters. The analysis results revealed that the feed rate (72.84%) was the dominant factor affecting surface roughness and the cutting speed (93.93%) was the dominant factor affecting flank wear. The optimum turning parameters for the lowest Ra values were A2B1C2 and for the lowest Vb values were A1B3C2. According to the results of gray relational analysis, the optimum parameters for minimum average surface roughness and minimum flank wear were A1B2C2. © 2019 World Scientific Publishing Company.

Açıklama

Anahtar Kelimeler

cryogenic treatment; Optimization; surface roughness; tool wear

Kaynak

Surface Review and Letters

WoS Q Değeri

Scopus Q Değeri

Q3

Cilt

Sayı

Künye