Experimental and statistical investigation of the effect of input parameters on output parameters in laser cutting of stainless steel material

Basit Öğe Kaydı
dc.authoridnas, engin/0000-0002-4828-9240;
dc.contributor.authorNas, Engin
dc.contributor.authorOzlue, Baris
dc.date.accessioned2025-10-11T20:48:10Z
dc.date.available2025-10-11T20:48:10Z
dc.date.issued2025
dc.departmentDüzce Üniversitesien_US
dc.description.abstractThis study experimentally and statistically investigated the effects of machining parameters on surface roughness and upper and lower kerf widths during the laser cutting of AISI 304 stainless steel. The experimental design was based on the L18 orthogonal array of the Taguchi technique. Laser cutting parameters included focal point (-4 mm and 4 mm), gas pressure (5, 10, and 15 bar), and cutting speed (5000, 7500, and 10,000 mm/min). The results showed that cutting speed and gas pressure reduced surface roughness up to a critical threshold. Additionally, increasing cutting speed decreased kerf widths, while higher gas pressure led to increased upper and lower kerf widths. Statistical analysis identified cutting speed as the most influential parameter for surface roughness (56.05%), upper kerf width (35.33%), and lower kerf width (66.33%). Finally, the Taguchi-based Grey relational analysis determined the optimal machining parameters as A2B1C3.en_US
dc.identifier.doi10.1177/03019233251349871
dc.identifier.issn0301-9233
dc.identifier.issn1743-2812
dc.identifier.urihttps://doi.org/10.1177/03019233251349871
dc.identifier.urihttps://hdl.handle.net/20.500.12684/21774
dc.identifier.wosWOS:001510103000001en_US
dc.identifier.wosqualityQ2en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isoenen_US
dc.publisherSage Publications Incen_US
dc.relation.ispartofIronmaking & Steelmakingen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.snmzKA_WOS_20250911
dc.subjectTaguchi-based grey relationalen_US
dc.subjectsurface roughnessen_US
dc.subjecttop kerf widthen_US
dc.subjectbottom kerf widthen_US
dc.subjectlaser cuttingen_US
dc.titleExperimental and statistical investigation of the effect of input parameters on output parameters in laser cutting of stainless steel materialen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu