Arşiv logosu
  • Türkçe
  • English
  • Giriş
    Yeni kullanıcı mısınız? Kayıt için tıklayın. Şifrenizi mi unuttunuz?
Arşiv logosu
  • Koleksiyonlar
  • Sistem İçeriği
  • Analiz
  • Talep/Soru
  • Türkçe
  • English
  • Giriş
    Yeni kullanıcı mısınız? Kayıt için tıklayın. Şifrenizi mi unuttunuz?
  1. Ana Sayfa
  2. Yazara Göre Listele

Yazar "Evran, Fatih" seçeneğine göre listele

Listeleniyor 1 - 8 / 8
Sayfa Başına Sonuç
Sıralama seçenekleri
  • Yükleniyor...
    Küçük Resim
    Öğe
    Azaltan DA-DA Dönüştürücüsü İçin Kayma Kip Denetleyici Tasarımı
    (2019) Evran, Fatih
    Bu çalışmada, sürekli iletim kipinde çalışan azaltan da-da dönüştürücüsü için ikinci mertebeden bir kayma kipdenetleyicisinin tasarımı sunulmuştur. Önerilen denetleyici doğrusal olmayan bir denetim türü olup, sabitanahtarlama frekansında çalışmaktadır. Yük ve giriş gerilimi değişimleri altında önerilen denetleyiciningeçerliliği PSIM benzetim sonuçları ile doğrulanmıştır.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Azaltan ve Yükselten DA-DA Dönüştürücüleri için Tek Çevrim Denetleyici Tasarımı
    (2019) Evran, Fatih
    Bu çalışmada, Azaltan ve Yükselten da-da dönüştürücüleri için sabit bir anahtarlama frekansında çalışan TekÇevrim denetim yöntemi sunulmaktadır. Önerilen denetleyici, doğrusal olmayan denetim türündedir ve heranahtarlama periyodunda anahtarlanan değişkenin ortalama değerini, referans işaretine eşit veya referansişaretiyle orantılı olmasını sağlamak için anahtarın doluluk oranını ayarlamaktadır. Bu denetim yönteminde,denetim referansı ile anahtarlanan değişkenin ortalama değeri arasında sabit bir hata veya dinamik hata olmadığıiçin sürekli durum hatası sıfırdır, aşma yoktur ve geçici cevap hızlıdır. Yük ve kaynak geriliminde görülen anideğişikler altında, önerilen denetleyicinin geçerliği PSIM benzetim programı ile doğrulanmıştır.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Design and control of an LCL-type single-phase grid-connected inverter with inverter current feedback using the phase-delay method
    (2019) Evran, Fatih
    In this study, a novel single-phase grid-connected microinverter system and its control applications areintroduced for solar energy systems. The proposed system consists of two stages to transfer solar power to the grid. Inthe first stage, an isolated high-gain DC/DC converter is used to increase low solar panel output voltage. In the secondstage, an inverter is used to supply a sinusoidal current to the grid. Moreover, a proportional resonant controller isadopted to reduce grid current total harmonic distortions (THDs) and an LCL filter is used to provide better harmonicattenuation. However, the ratio between the sampling frequency fs and the resonance frequency fres should be greaterthan 6 in the LCL filter with the inverter current feedback for a stable system. In order to obtain higher phase margins,the sampling frequency should be increased, which increases the inverter switching frequency. The present study showsthat fs/fres can be lower than 6 by placing a phase delay on the inverter current feedback path to guarantee adequatestability margins. The effectiveness and feasibility of the proposed method are confirmed by the experimental test resultsbased on a 300-W laboratory prototype.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Grid Connected Inverter
    (2018) Evran, Fatih
    This paper presents solar based single phase grid connected inverter system. In such a system, DC-DCconverter is both used to boost low PV panel voltage and ensures that the solar panel operates atmaximum power while Full bridge inverter injects the maximum power from the solar panel to thegrid. The system is reliable because it does not cause control complexity and also it is preferred toobtain a low THD (Total harmonic distortion). But, the main disadvantages of the converters such as aboost or a flyback type are limited voltage gain and low efficiency. In the proposed topology, the DCDC converter with galvanic insulation and high voltage gain characteristics can connect a low-voltagesolar panel to the grid. Simulation results are given for the system which inverts MPPT voltage rangeof 20-30 V DC to grid voltage of 220 V(rms) at power range of 60-300 W with a unity power factor.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Güç Dönüştürücülerinin Kapalı Döngü İçinde Benzetimi
    (2018) Evran, Fatih
    Bu çalışmanın amacı, güç dönüştürücüleri için kapalı döngü içerisinde etkili bir benzetim ortamı oluşturmaktır.Kullanılan benzetim gerçek zamanlı olup, geleneksel benzetim yazılımlarından farklıdır. Gerçek zamanlıbenzetimlerde yüksek hassasiyetli sonuçlar elde edebilmek için örnekleme zaman aralığının oldukça küçükolması gerekmektedir. Bu ise sistemin maliyetinin artmasına yol açmaktadır. Bu çalışmada, açık kaynaklı birişletim sisteminde, güç dönüştürücülerinde durum uzay ortalama yaklaşımını kullanarak gelişmişmikrodenetleyiciler için çok düşük maliyetli gerçek zamanlı bir donanım test ortamının ayrıntılı bir uygulamasısunulmuştur. Örnek olarak, AA (Alternatif akım)-DA (Doğru akım) güç faktörü düzeltme dönüştürücüsünündenetleyicisi tasarımı için gerçek zamanlı bir benzetiminin test yaklaşımı uygulanmıştır. Önerilen gerçek zamanlıbenzetimin geçerliliği MATLAB/ Simulink benzetim sonuçları ile karşılaştırılarak doğrulanmıştır.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Isolated High Step-Up DC-DC Converter With Low Voltage Stress
    (Ieee-Inst Electrical Electronics Engineers Inc, 2014) Evran, Fatih; Aydemir, Mehmet Timur
    Fuel cell stacks and photovoltaic panels generate rather low dc voltages and these voltages need to be boosted before converted to ac voltage. Therefore, high step-up ratio dc-dc converters are preferred in renewable energy systems. A new Z-source-based topology that can boost the input voltage to desired levels with low duty ratios is proposed in this paper. The topology utilizes coupled inductor. The leakage inductance energy can efficiently be discharged. Since the device stresses are low in this topology, low-voltage MOSFETs with small RDS (on) values can be selected to reduce the conduction loss. These features improve the converter efficiency. Also, the converter has a galvanic isolation between source and load. The operating principles and steady-state analysis of continuous and discontinuous conduction modes are discussed in detail. Finally, experimental results are given for a prototype converter that converts 25 V dc to 400 V dc at various power levels with over 90% efficiency to verify the effectiveness of the theoretical analysis.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Plug-in repetitive control of single-phase grid-connected inverter for AC module applications
    (Inst Engineering Technology-Iet, 2017) Evran, Fatih
    This study presents two-stage inverter topology for single-phase grid-connected photovoltaic (PV) applications and its control implementations. The two-stage systems are reliable and work well. Typically, the second stage inverts solar power into AC power, whereas the first stage which is used to increase low PV panel voltage can achieve maximum power point tracking. In this configuration, a boost or a flyback type DC/DC converter topology is usually employed. However, such converters have major drawbacks such as low efficiency and limited voltage gain due to power losses. In the proposed topology, a low-voltage PV panel can be connected to power grid through solar inverter by using high-gain DC/DC converter which has unique features such as galvanic isolation and continuous current for AC module applications. Conventional controller results in poor control performance due to the finite gain at desired frequencies. Hence, a plug-in repetitive controller is proposed to obtain low total harmonic distortions (THDs). The performance of the proposed system is provided for the system which injects the PV panel current in the maximum power point voltage to a grid of 220 V-(rms) at a power range of 150-300 W with a unity power factor and a low input current THD.
  • Yükleniyor...
    Küçük Resim
    Öğe
    Tek Kademe Dönüştürücülü Güç Elektroniği Trafosunun Tasarımı
    (2018) Evran, Fatih
    Güç elektroniği trafoları, manyetik çekirdeği ve iletken sargıları oluşturmak için gerekli olan demir ve bakırmiktarını azaltarak geleneksel dağıtım trafoların boyutunu ve maliyetini düşürme potansiyeline sahiptir ve ortaölçekli frekanslarda trafo çekirdek boyutunu düşürmektedirler. Önerilen topoloji, diğer topolojilerle ilekıyaslandığında güç elektroniği trafosunun hem maliyetini hem de fiziksel boyutunu azaltmayı sağlamayıhedeflemektedir. Son olarak, teorik analizin etkililiğini doğrulamak için kullanılan dönüştürücü için benzetimsonuçları verilmiştir

| Düzce Üniversitesi | Kütüphane | Açık Erişim Politikası | Rehber | OAI-PMH |

Bu site Creative Commons Alıntı-Gayri Ticari-Türetilemez 4.0 Uluslararası Lisansı ile korunmaktadır.


Düzce Üniversitesi, Kütüphane ve Dokümantasyon Daire Başkanlığı, Düzce, TÜRKİYE
İçerikte herhangi bir hata görürseniz lütfen bize bildirin

DSpace 7.6.1, Powered by İdeal DSpace

DSpace yazılımı telif hakkı © 2002-2025 LYRASIS

  • Çerez Ayarları
  • Gizlilik Politikası
  • Son Kullanıcı Sözleşmesi
  • Geri Bildirim